Logo

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

08.06.2025 11:18

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.

So, the voltage could go up to 500 volts, and the fuse will not open up.

But… the neutral is now “floating” because of the 1 ohm resistance.

7 Thoughts on Grand Slam Track Philadelphia: Melissa Jefferson-Wooden & Kenny Bednarek Rule the Sprints, Hello Nico Young, & More - LetsRun.com

2024–10–11 [Bobby Sanchez Bobby Sanchez ].

What does a fuse do?

So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.

Sophia Bush Says She Endured “Every Kind of Abuse” on Show Due to Older Man - The Hollywood Reporter

Barnstars:

so, what happens?

The bolt then partially travels down the line to your home.

CVS to shutter 5 pharmacies in New York amid closure of 271 stores nationwide - New York Post

It seems Mohan does not understand the difference between a comment and an Answer.

So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.

The MOV will conduct when the voltage exceeds 50% of line voltage.

In what ways is Bollywood becoming westernized?

2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?

Now when you have a certain ac resistance, then a current flows in a loop.

eight

Terraforming Mars Might Actually Work and Scientists Now Have a Plan to Try It - ZME Science

There are three different concepts here that are getting confused.

Because the load is inductive, the current lags the voltage.(by a bit).

This is the picture of an electronic coil of wire wound around a core of magnetic material.

Why do Democrats never produce a good argument for why Trump was a bad president?

2024–10–10[John johnson John Johnson ]

At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.

This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.

'The Life of Chuck' Filmmaker Mike Flanagan on Stephen King Film - IndieWire

A fuse is a non-resetable over current circuit protector.

I post the exact comment here.

If the nominal power is 4,000 watts then the current at 230volts is 16 amps.

What does success really mean to you? Is it about happiness, money, or something else?

This is where this question deviates from being a 'generic' question, and becomes more specific.

This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.

(Dc diagram shown, AC is similar).

What are your funniest "lost in translation" moments if you grew up speaking more than one language?

An AC voltage/ current source, and an ac inductive load.

the problem then depends on "how fast does the fuse operate?".

Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".

Trump administration eyes stripping Columbia's accreditation - BBC

[old diagram got deleted by accident]

This device then solves the entire problem.

But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).

First Sentence:

One is “what exactly is in a ‘surge protector’ ? ”

And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.

He then describes Rainy Season and Lightning.

Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.

so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.

Here is a simplified AC power diagram.

Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.

what exactly is a ‘surge’ protector?

This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.

OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.

P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.

In schematic diagrams this is the symbol for a fuse:

When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.

“ A fuse is a device which protects the (circuit) against overload and short circuit.”

What is lightning?

“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”

(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).

It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.

At one ohm, the resistor has a maximum of 1 watt power.

One

A circuit breaker is similar, but is resettable.

2024–10–00 [ Ammar Mahdi ] Ammar Mahdi

2024–10–14 [Omar Gharbi Omar Gharbi ]

Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.

The third is lightning and “how it gets conducted into a home.”

2024–10–11 [Victor Olarewsju Victor Olarewaju ]

These are simplified answers to the original question, and does not change anything I wrote above.

But it can get overloaded, and no longer works.

Edit 2024–10.

This is 'the assistant's answer'

This one hit behind the barn.

a photo is worth a thousand words.

but I think this circuit , shows a few more pieces.

Can the fuse protect the electronic devices from lightning instead of a surge protector.

There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.

At least they know the answer if they wanted it.

This is where the MOV conducts again, and dissipated the energy.

Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.

He then describes the function of a fuse.

There are two important concepts here.

2024–10–16 [ OO OLAOYE OYEBODE ]

[image of Common-mode choke]

“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”

but this device (an Inductor) … impedes the rapid changes in the current.

It also is a device that limits the change in current flow.

He then asserts :

nine

These devices are installed between the “hot” and “neutral” and protective ground.

Upvotes:

For this case there are devices called Metal oxide varistors (MOV).

The other is “what does a “fuse” do?”